Engine – CPR Kart Parts

EMTC8832 Engine Mount assembly & install

a. Fit the 4x M8x50 Socket Head bolts through the top plate from the […]

EMTA02 G13 Engine Mount Billet Fully AdjustableI recently bought this engine mount to avoid

*NOTE: SETTINGS BELOW ARE RECOMMENDED AND MAY NOT BE IDEAL FOR YOUR ENGINE SETUP. USE

Fitting Guide/Instructions THE WELDIN To be fitted preferably, on the inside of a bend,

THROTTLE CABLES – THE DEFINITIVE GUIDE TO SELECTING THE CORRECT ONE FOR YOUR RACE

CYLINDER HEAD TEMPERATURES – Why they matter & optimal temps for air-cooled race engines

Are you getting a bit hot under the collar (or your right side and

Measuring the port spreadUsing an old ring and a piston to slide the ring

If you’re looking for a new sprocket, or a clutch for your KT100J or

Material: Diecast AluminumWeight: 3.8lbsTiming: 28 Deg.Fins: 12 AKRA & WKA Approved This flywheel is

For those of you mounting and ST1 (or Stage 1 or Stage 2) engine

ENUCL39 GX390 Hop Up Kit Installation Guide CLICK HERE TO FIND THIS KIT IN

CPR BILLET THROTTLE LINKAGE KIT INSTALL You can find this kit in our store

GUIDEInstalling our 10hp sports hop-up kit on GX200 & Clone Engines This month, we’re

To set your jets to baseline, turn both fully in then: Rough initial settings:

Are you searching for all the gaskets required to rebuild the ENCL65 or ENCLST1

This guide is designed to assist with basic teardown and assembly of GX160 and

Is your CPR 10hp Engine (ENCLST1_12 or similar) leaking fuel from the air filter,